Refer a friend (who mentions your name when booking)
& receive A DISCOUNT on your next service or Duct Clean!
.
A duct cleaning service for up to 2500 sq ft. $489.95 + GST. More feet at an additional cost. With every Duct Clean, get the furnace inspected at NO EXTRA CHARGE!
- Inspect operation of the thermostat
- Inspect furnace for proper operation
- Inspect/clean furnace flame sensor & burners
- Clock furnace from gas meter to make sure fired correctly
- Inspect and tighten all electrical connections as required
- Check for any present or potential fire hazards
- Inspect condensate drain lines for proper drainage and potential leaks
- Thoroughly vacuum the furnace
- Replace filter (common sizes only)
- The entire duct work in house hot runs, cold air returns & the main trunk line (Brushed, Air whipped and sucked out, 2 step process)
- Visually check all accessible duct work for potential leaks ~ if possible
- Inspection to the hot water tank
- Inspection to the gas fireplace
- Free filter (common sizes)
This service includes a thorough inspection of the hot water tank & a free filter, all performed by one of our Licensed Gas Fitters. $229.95 + GST.
- Inspect operation of the thermostat
- Check operation of safety limit controls
- Lubricate blower and motor bearings as required
- Clean and inspect blower assembly
- Check blower speed and operation
- Check pressure switches and vent blower (if applicable)
- Inspect burners and clean if required
- Check and adjust pilot light (if applicable)
- Check flame rectification
- Measure stack (flue) temperature
- Check gas piping to furnace
- Check and adjust manifold gas pressure
- Clock appliance to verify correct input
- Combustion / ventilation air adequate
- Check for elevated carbon monoxide levels
- Inspect heat exchanger
- Clean equipment interior/exterior
- Clean air filters and re-install – Instruct customer on filter maintenance
$489.95 + GST
- Inspect operation of the thermostat
- Check refrigerant charge level
- Inspect all visible refrigerant lines for leaks
- Inspect and monitor the starting capability of the system
- Check voltage and amperage draw on the compressor and motor
- Monitor the air temperature for proper cooling
- Visually check all accessible duct work for potential leaks
- Lubricate all moving parts as required
- Inspect and adjust the blower and blower components as required
- Inspect and tighten all electrical connections as required
- Inspect all safety controls for potential defects
- Service all present drain pumps as required
- Inspect electrical circuit breakers and fuses for proper size and potential defects
- Inspect drain lines for proper drainage and potential leaks
- Check for any present or potential fire hazards
- Thoroughly clean the indoor coil and outdoor condenser
Only $129.95 + GST! Some conditions apply. We use an innovative disinfectant cleaner to deodorize and disinfect our duct work. Benefect® Decon 30 Disinfectant is specially formulated to kill gram-negative and gram-positive bacteria in just 30 seconds! For more info, click here
Only $289.95 + GST!
$475 + GST for 2.5 hour minimum. ($190/hr)